The chip gets read into the buffer, then the buffer gets saved to file. Load File To Buffer – Pressing this button will bring up an expolorer dialog to select a file with which to fill the buffer. If you see this instead: The New Hardware Found prompt should pop up and then go through the wizard, but when you get to the prompt where you can change to where the file is located, select the folder where you unzipped the usb files and let it finish installation. If that happens then you have successfully setup the chip burner and software and ready to burn you some chips. Program Chip – This will perform the action of programming the chip.

Uploader: Gardabei
Date Added: 8 November 2014
File Size: 7.3 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 28608
Price: Free* [*Free Regsitration Required]

Failing blank checks is a common sign of fake chips. Don’t put it in backwards! If it is on one of the COMs then memorize the number.

Moates BURN2 Chip Programmer

Getting StartedTroubleshooting. Once everything is installed, go and download Tuner Pro located on Moates. Verify Chip With Buffer – This will read the contents of the chip at and between the locations specified in the “Chip Addressing” fields and compare them against the data in the buffer at the location “Buffer Addressing” field “Start Address.

If this test passes, you can be confident that the chip flassh programmed correctly. Select the chip you are burning in the top scroll bar.


If it fails the blank check, try another chip. Newer versions of TunerPro perform auto-detection which should keep you from having to worry about this part.

Moates BURN2 Chip Burner – Programmer

Erase Chip – Pressing this will erase the entire contents of the chip from beginning to end. We will be selecting the correct buffer and chip addressing to ensure the chip is burned properly and can be used. In most cases, the software will automatically set these for you. Note – All addresses and filesizes must be 64 byte aligned. It reads the chip contents from the specified “Chip Addressing” fields ane places them at the beginning flassh the buffer.

To File – To read a chip to a file: You’re likely to burn something other than the chip! The buffer is then burned to the chip.

Check and make sure the chip is inserted firmly in the socket. It makes use of the current buffer and burns the chip from the data in the buffer specified in the “Buffer Addressing” fields and burns the information to the chip at the location specified in the “Chip Addressing” fields.

If your burner fails to erase several different chips, you probably have fake chips. Programming chips with offsets comes into play in two situations:. Once opened you can go over to the Tools tab, then go to the preference tab. Load File To Buffer – Pressing this button will bring up an expolorer dialog to select a file with which to fill the buffer. Double check addressing settings. He walked me through all these steps as I wrote for you.


You asked, we deliver! Blank Check – This will check the entire chip and return success if the chip is blank, or failure if mates chip is not blank or upon error. The chip gets read into the buffer, then the buffer gets saved to file.

Flash & Burn Program for BURN1/2/Jaybird+APU1 [FLASHBURNPRO] – :

You can register the software for 30 bucks later, which I plan on doing soon. Also, input the address within the chip that you’d like that portion of the buffer to be programmed to. This reads the chip into the local buffer. The following table summarizes what offsets you need moatew use depending on chip used moayes file size: Once you do have it on a COM supported, go back to the port setting tab and then select the Bits Per Second tab and change it from to then hit okay this is optional.

If it passes a blank check, try programming it again.